TECHNICAL SPECIFICATION
Réf: GF0610B Ref Mcmining:PRGF0610B-AM Tournevis, lame cylindrique 6 x 100mm GF0610B BeCu
Brand: AMPCO
| | Specification Technique:
Description |
Les
outils anti-etincelles et amagnetiques Ampco font partie integrante de la
panoplie du professionnel exerçant son metier dans des environnements a
fort risque d’explosion ou d’incendie,protegeant ainsi sa vie.celle
des autres et les sites sur lesquels il intervient;par exemple raffineries,
entrepots, distribution de gaz, fabrication de poudre ou explosifs,maintenance
de pipe-lines,plates-formes de forage petrolier,silos a grain,ainsi que
dans des cadres militaires comme le deminage. |
Keep
the screwdriver handle clean; a greasy handle is apt to cause an accident.Use
a screw-holding screwdriver to get screws started in awkward, hard-to-reach
areas.Screwdrivers used in the shop are best stored in a rack. This way,
the proper selection of the right screwdriver can be quickly made. Use a
ratchet-type screwdriver for speed and comfort when a great number of screws
are to be driven.A rounded tip should be redressed with a file; make sure
the edges are straight.Use an offset screwdriver in close quarters where
a conventional screwdriver cannot be used. |
Don't
use a screwdriver with roundededges or tips; it will slip and cause damage
to the work or yourself.Don't use pliers on the handle of a screwdriver
to get extra turning power. A wrench should only be used on the square shank
or bolster of a screwdriver that is especially designed for that purpose.
Don't hold the work in one hand while using the screwdriver with the other.
If the screwdriver slips out of the slot (wetold you to use the right size
screwdriver!) you will be most likely to receive a gash on your hand.Don't
use a screwdriver for prying, punching, chiseling, scoring, or scraping.Don't
use a screwdriver to check a storage battery or to determine if an electrical
circuit is live.Don't expose a screwdriver blade to excessive heat as it
may reduce the hardness of the blade.Don't use a screwdriver near a live
wire or for electrical testing.Don't use a screwdriver with a split or broken
handle.Don't use a screwdriver for stirring paint. |
Certifications |
- ISO9001
AMPCO SAFETY TOOLS Beryllium Copper (BeCu) alloy helps fulfill the recommendation
in :
- European ATEX directive
for working in Zones 0 and/or 20 of all explosion groups, and M1 , M2 for
Mining.
- BAM (FEDERAL
INSTITUTE FOR MATERIALS RESEARCH AND TESTING Berlin Germany) Standard operating
procedure “QMH-NEG-005” “StAA zur Schlagfunkenprüfung
von Werkstoffpaarungen” dated 2012-03-01 : the non-sparking tools
made of these materials are appropriate for use in potentially explosive
atmospheres of zone 0, 1, 2 and 20, 21, 22 according to directive 1999/92/EC
of all explosion groups according to IEC 60079-20-1:2010.
- EN 1127-1 and EN 13463-1 |
Specification |
REF |
a
mm |
b
mm |
l
mm |
g |
|
GF0610B |
6 |
100 |
200 |
80 |
|
|
|